Safety Training

HYTORC take operator safety very seriously. Hydraulic tools and bolting systems are very safe when used correctly.

Although we build extensive safety features into all our products, Hytorc owners and users are entitled to a number of training and safety benefits.

These include Safety-Training on Request and a FREE Annual Safety Seminar on Appointment.

This is in addition to the training that users of new HYTORC equipment receive.

For further details Please Contact us

Safety Notice

For Operation of all Brands of Hydraulic Torque Tools

Power tools should only be operated with hard hat, safety gloves, goggles, steel-toe boots, ear plugs and without loose clothing
Hands-Off - Hydraulic Torque Tools. If at all feasible stay distant from tool under pressure or hold handle in a safe position
Unless there is CLEAR Communication - Tool Operator operates the pump!!!

Before using Hydraulic Torque Tools, Please Run These Safety Tests:

Pressurise the tool on the ground and cycle it several times at maximum pressure to check tool, hoses and pump for function and leaks. Replace hose and fix tool or pump in case of leak or functioning irregularities prior to use
Check tool and reaction arm for cracks and badly worn areas and replace if so
Check socket for cracks and badly worn areas and replace if so.
Check backup wrench for cracks and badly worn areas and replace if so

Please stay distant from tool hoses and pump during safety test

Tool Setup:

Assure tight screw-connectors (without gap). Set required pump pressure with tool connected. Firmly connect socket to drive. For Tool Set-up loosen screw connectors half a turn if pump operator is distant from job to avoid inadvertent start-up while handling the tool. Re-tighten thereafter.

Reaction Arm Setting:

The reaction arm of the tool should be placed in the same direction as the drive whenever possible so as to about firmly against the adjacent nut or the casing. Please test by placing tool on the nut, apply pressure to make sure reaction is firm and tool does not rise. If it does, reset the reaction arm.

Tool Holding:

On vertical or inverted applications, please hold tool so that even if there is a failure of tool or socket you are out of harm's way. On horizontal applications, take hands-off when tool is in use! Request supplier to give you free user training prior to first use! Or call 01670 363800

NEVER...

Never hold the tool on connectors or swivel during operation
Never place the tool on job without partially disconnecting both hoses when pump operator is out of sight
Never use leaking tools or hoses
Never have your face close to the socket during operation
Never place your hand on reaction arm or swivel when pump is operating
Never place your hand on operating tool if not absolutely necessary
Never use altered, heavily used, damaged or chrome sockets